Stainless steel pipe making machine is a professional processing equipment, which can process stainless steel material into pipes of various specifications, widely used in chemical, petroleum, pharmaceutical and other industries. In order to ensure the normal work of stainless steel pipe making machine and improve the processing efficiency and quality, you need to follow the following steps for commissioning and maintenance.
Preparation work before commissioning
1, According to your processing needs, select the appropriate stainless steel pipe making machine model, to confirm that the various parts of the equipment is complete and intact.
2, Choose a clean, ventilated workplace, ensure that the power supply and electrical lines comply with safety standards to avoid accidents such as electric shock or fire.
3, In all the lubrication points of the equipment to add the appropriate amount of lubricant, and then turn on the equipment for preheating, so that it reaches the best working condition.
Installation and commissioning steps
1, Before turning on the machine, you need to carefully check whether each part of the equipment is fixed firmly, if you find any loose, tighten it in time.
2, After starting the machine, switch to manual mode, and test the operation of each part one by one in accordance with the working order of the equipment, if any abnormality is found, stop the machine immediately and remove the faults.
3, Adjust the position of the feeding wheel and guide plate to match the pipe specification you want to process, and then test the feeding and blanking process respectively in manual mode to make sure the pipe can enter and come out smoothly.
4, Switch to the automatic mode, carry out trial processing, according to the processing effect, adjust the parameters of the equipment, such as speed, pressure, temperature, etc., so as to make it reach the best processing state.
5,Check the size and standard of the tube out of the trial processing, whether it meets your requirements, if there is deviation, adjust the equipment or replace the roller in time.
6,Carry out formal continuous processing, observe the operation of the equipment, check whether the processed pipe is flat and consistent, if there is any problem, stop the machine and deal with it in time.
7,After processing is completed, turn off the equipment, cut off the power supply, clean up all parts of the equipment, remove dust and sundries, and turn off the water and gas sources.
Common faults and solutions
1、If you find that the pipe processed by the equipment is not flat, or the size is not consistent, you can try the following methods:
1.1, Adjust the position of the feeding wheel and the guide plate, so that it is compatible with the diameter and thickness of the pipe.
1.2, Check the sharpness and clamping force of the working tool, if it is worn or loose, replace or tighten it in time.
2、If you find that the processing speed of the equipment is too slow, you can try the following methods:
2.1, check whether the power supply and electrical wiring is normal, whether there is any broken or short circuit and so on, if there is, repair or replace it in time.
2.2, Switch to the automatic mode that suits your processing needs, and adjust the speed parameters of the equipment to maximize its efficiency.
3、If you find the equipment has abnormal sound, flashing and other abnormalities, you can try the following methods:
3.1 Immediately turn off the equipment, cut off the power supply, check whether the various parts of the equipment are damaged or loose, if so, replace or tighten them in time.
3.2 Clean the surface and interior of the equipment, remove dust and debris to prevent affecting the heat dissipation and operation of the equipment.
Guangdong Hangao Technology Co.
Recommended reading:Stainless steel pipe making machine
Recommended reading:Servo heavy duty weld bead rolling machine
Hotline:189-4243-7326
